Ceci est une ancienne révision du document !
Don't worry Blender fans. Nicholas will be back next month. His excuse this month was something about getting married. This month we’ll look at restoring old and damaged photographs using GIMP. For this example I’m going to use a photo of my late grandfather as a child.
Ne vous inquiétez pas fans de Blender. Nicolas sera de retour le mois prochain. Son excuse ce mois-ci avait quelque chose à voir avec se marier.
Ce mois-ci nous allons voir comment restaurer des photographies anciennes ou endommagées en utilisant GIMP. Pour cet exemple, je vais utiliser une photo de mon grand-père alors enfant.
It’s a very old photo taken in the early 1900’s so the dark and light colors aren’t as pronounced as they could be, but even fixing that won’t repair the damage, but GIMP will. Once we have the photo restored we can do some basic color correction to it.
C'est une très vieille photo prise dans le début des années 1900 c'est pourquoi les couleurs sombres et claires ne sont pas aussi prononcés qu'elles pourraient l'être, mais même corriger cela que ne réparera pas les dégâts du temps, mais GIMP le peut. Une fois que nous aurons restauré la photo, nous pourrons faire un peu de corrections basiques de ces couleurs.
The Clone Tool In the tool box, choose the Clone Tool icon (shown left). What this does is let you select a source within the image which it will clone to wherever you paint. Let’s start easy and go with the crack to the left of his head. There are no details in/behind it, so it should be easy to repair. Here’s the steps I take to repair it:
L'outil de Clonage
Dans la boîte à outils, cliquez sur l'icône Outil de clonage (voir à gauche). Ce qu'il se produit est que cela vous permet de sélectionner une source au sein de l'image que l'outil va reproduire à l'identique à l'endroit où vous peignez. Commençons facile et avec la fissure à la gauche de sa tête. Il n'y a pas de détails dans / derrière, donc elle devrait être facile à réparer. Voici les mesures que je prends pour réparer:
I select the clone tool then a suitable sized brush (with a soft edge) which has a diameter larger than the width of the crack. You’ll notice that the pointer has a stamper icon beside it and a no entry icon. This is because I have not chosen a source yet, so the tool is not ready to use at the moment.
To choose a source, I hold down CTRL and left-click above the crack at the point where I want to start from. Please note: the source you choose has to match where you’re going to clone it. If I chose a source above the middle of this crack then go from left to right it would not match.
With the source chosen I now hold down the left mouse button and draw over the crack in one motion. If I stop-start, it will reset the source and not match where I am in the motion.
And that is the magic of the clone tool. You follow that procedure for each crack or blemish on the photo. The tricky part arises when you get to things like the vertical bar in the window backdrop; it must match, and it will take a few tries before you get it; the source will need to be above/below where you’re painting.
It’ll take a bit of practice, but you’ll get there in the end. Middle right what I have after a few minutes of Clone Tool action.
After I’ve removed all the cracks I apply some basic color correction (shown bottom right).
Obviously you remove all the blemishes then do your color correction, but I just wanted to give you a brief introduction to the power of the clone tool.